Step 1.
Use a template. (Attached to a door knob) and remove this template to the door in a position to determine the use of steel-tipped marker on the door.
Step 2.
Use a drill for drilling holes for example, use the knob to set the knob to penetrate. Used to penetrate the front of the door. Position and drill the marked side of the ridge. Rato, using flowers into the water when the lock.
Step 3.
Cover, place the logs in place, install the lot. C and then draw a line around the cover. Then use a chisel care. I leave the wood to a depth equal to the thickness of the crown spread.
Step 4.
The pivot lock of the door to the ridge cap t. A month, then tighten the screws holding the cover tightly to her. Twist the outside of the room, followed by the. Is available by following the procedures of the company. Manufacturer’s knob.
Step 5.
To break the lock on the edge of the frame by pivot gives. Weird hole drilled in the same position with the lock.
Step 6.
Installation plate by placing a sheet of a shock. Between the tag and then cover the hole. Potential of being published. Using a chisel and shovel to a depth equal to the thickness of the sheet to rapidly impact the screws to hold it firmly.
pitimalee 